Here are our answers to most of our frequently asked questions. If you cannot find an answer to your question, please contact us via email at tech@mazworx.com. Please do not call our sales line for technical questions. Thank you very much.

We have not tried fitting the kit with a VH41 engine so we are not sure if it will work or not.

We suggest you use the 300zx Z32 starter.

As far as gear ratios and bellhousings are concerned, there are no differences between those two transmissions. The only difference is in the 1996 Z32 T/T transmission, as that version came with stronger 4th gear synchros.

The kit will not work in a 300zx chassis. However, the adapter plate for VH to VG transmission will work. At this time, we do not have plans to develop a kit in the near future.

You should retain the clutch that is existing on the motor. The VH-VG kit will use a 90-96 300zx turbo clutch and flywheel.

Depending on which DET you are using, we have the complete adapter/changeover kits available.

This could be due to several factors. The factory hydraulic setup has very limited power options and does not like being bounced off the rev-limiter or being used on anti-lag. Our best suggestion is to either switch over to a solid pivot setup and do a dual guide conversion or swap over to the VVL cylinder head.

This question has so many variables. It all depends on the condition on the motor, tuning etc. Unfortunately, we do not have an exact answer to this but the range is MINIMUM to MAXIMUM.

Please refer to our product instruction section for the removal of bellhousing instructions. All you need to send us is the bellhousing itself.

Intercooler setups always follow the corresponding engine, not the chassis. In this case, the answer would be an intercooler for the S14.

We recommend using the 1/2″ cylinder head studs for engines producing over 600HP.

To degree your cams in, you should follow the specificiations based on the manufacturer of the camshafts. For a more detailed information on degree cams and what they do, please follow the provided link. Thanks to Kelford Cams for providing such great information! The Sole Purpose of Degreeing Your Cams

We highly recommend that you run the stock pulley or a harmonic dampened pulley (like ATI). The factory crank pulley has a built-in harmonic dampener, in the form of a split design, with a thick rubber pad sandwiched between two steel sheels. The dampener is designed to absorb torsional and vertical vibrations from the crank. Most underdrive crank pulleys do not have a harmonic dampener at all. Torsional vibration is a twisting vibration caused by the pulses of each combustion event. The force of the piston causes the crank to deflect ever so slightly in the direction of the force, and when that force goes away the crank ever so slightly springs back. At certain frequencies the crank can resonate, making the vibration much worse. This is where the harmonic dampener comes into play. The harmonic dampener will absorb most of the vibrations that alot of the motors create especially the ones that turn at higher rpm’s.

As this is one of our most frequently asked questions, we have created a short write-up concerning this topic. Please click on the link below or copy and paste it. VVL Head Conversion